Back to BlogSafety

Commercial Electrical Emergency in Nottingham: What to Do in the First Hour

Somo Electrical Team16 October 20267 min read

In a commercial electrical emergency, the first hour is about people rather than power: move everyone away from the fault, touch nothing and switch nothing, call 999 if there is fire, smoke or an injury, call the free national power cut line on 105 if neighbouring premises are dark too, and call a qualified electrician for anything confined to your own building. Opening a panel or isolating a circuit is not on that list. That part is for a qualified, registered electrician.

Two clocks run in a commercial emergency. The safety one is immediate; the trading one feels just as urgent and is not, and most of the avoidable harm comes from a rushed restart rather than from the wait. Below is the sequence we would want a shop, salon or small office in Mapperley to follow.

What counts as a commercial electrical emergency?

An emergency carries an immediate risk of injury, fire or serious damage. A fault is something you book in. Treat these as emergencies and clear the area:

  • A burning smell, smoke, visible sparking, or buzzing or crackling from a board, isolator, socket or fitting
  • Anyone receiving an electric shock, however slight
  • Scorch marks, discolouration or heat on a socket front, switch plate or plug
  • Water reaching electrical equipment or a board — a burst pipe, a roof leak, a flooded cellar
  • Power lost to your premises alone, where neighbouring units are fine and a breaker will not stay in
  • Fire detection or emergency lighting out of action while the premises are occupied

A single dead socket, or one circuit that trips once and then holds, is a fault rather than an emergency — see why an RCD keeps tripping.

What should you do in the first hour?

In order, and the order is the point. Every step is safe for anyone on site, and none involves touching the installation.

  1. People away from it first. Move everyone back and keep them back. If there is smoke or fire, evacuate on your own fire plan.
  2. Call 999 for fire, smoke or injury. Any electric shock needs medical assessment even where the person feels fine. Do not touch anyone who may still be in contact with the source — call 999 and follow the operator.
  3. Touch nothing and switch nothing. Do not reset a breaker that has tripped, do not open a board, and do not unplug or move anything hot, wet, smoking or sparking.
  4. Work out whether it is yours or the network's. Look outside at the street lighting and the units either side.
  5. Call a qualified, registered electrician with four things ready: the address and access, what is affected and what is not, what was seen or smelled and when, and whether the premises are occupied. Ask the out-of-hours attendance and charging terms before anyone travels.
  6. Keep the area clear by exclusion, not intervention — a barrier, a sign, and someone standing there where the public can reach it.
  7. Write it down while it is fresh — the time, what happened, who was present, who you called, what you were told — and photograph it from a safe distance.
  8. Do not make the trading decision alone. It belongs to the person responsible for fire safety at the premises and to your electrician.

Is the fault yours, or is it the network's?

If neighbouring premises or the street lights are out too, the problem is upstream of your building and no electrician can fix it. Ring 105, the free national power cut line, available around the clock and routed to the local distribution network operator — for Nottingham, National Grid Electricity Distribution, which also publishes a 24-hour faults number, 0800 096 3080, and a live outage map. If the power is off in your unit alone, it is your installation and an electrician's job.

Knowing which in the first few minutes changes the whole hour: a network outage with nothing wrong on your side is a continuity problem — fire detection, stock, tills, shutting servers down properly — rather than a repair.

Who pays for the downtime?

Honestly: we cannot tell you, and your electrician is the wrong person to ask. In leased premises it turns on the repairing and service covenants in your own lease, any limitation clauses in it, and whether you hold business interruption cover — for a commercial property solicitor and your insurer, not a contractor, to read. Treat confident answers online with caution: published guidance on commercial landlord and tenant responsibility is demonstrably inconsistent, and some of it imports rules that apply only to residential lettings.

What protects your position either way is a written record made at the time, prompt notification to the landlord or managing agent and to your insurer, and the electrician's report and dated invoice kept with it. On safety duties around electrical equipment at work, the authority is the Health and Safety Executive at hse.gov.uk, not a contractor's website — ours included.

What should you not do, whatever the pressure to reopen?

  • Do not keep resetting a breaker. It operated because it is detecting something; forcing it back in is a fire risk, not a workaround.
  • Do not isolate, switch or investigate at the board. Not the main switch, not "just having a look". Cutting the supply is for the network operator or an electrician.
  • Do not improvise a supply. Daisy-chained extension leads, or one circuit carrying what three used to, is how the second incident happens.
  • Do not treat the lights coming back on as the all-clear. Power returning tells you nothing about why it went.

Can you keep trading, and when can you reopen?

Two decisions, and neither is the electrician's alone. The safety one comes first: where fire detection or emergency lighting is affected, whether the premises can be occupied is for the person responsible for fire safety there and for the premises' fire risk assessment, which sets the control measures while a life-safety system is down. Our guide to emergency lighting testing requirements sets out the regime those systems sit under, and after a long loss of mains the units themselves want checking.

The electrical one follows: an electrician finds the cause, puts it right, tests the affected part before power returns to it, and says in writing what was wrong. If that turns up a wider problem with the fixed wiring, the next step is an inspection of the whole installation rather than another callout — see what happens on the day of a fixed wire test.

Frequently asked questions

Should I turn the power off at the main switch in an electrical emergency?

Not on our advice, and certainly not if the board or isolator is itself hot, wet, smoking or sparking — approaching it is the hazard. Keep people away instead, and leave cutting the supply to the network operator or a qualified electrician. In a fire, tell the 999 operator the cause looks electrical and where the board is.

Is an electric shock with no visible injury still an emergency?

Yes, on both counts. The person needs medical assessment even if they feel fine, because effects can be delayed and are not always visible. And the circuit or equipment that delivered it still has a fault, so it should be taken out of use and left alone until an electrician has found the cause.

Who do I call if the power is off across the whole street?

Call 105. It is free, available 24 hours, and routes to the distribution network operator for your area — National Grid Electricity Distribution in Nottingham, which also runs a 24-hour faults line on 0800 096 3080. An electrician cannot restore a network supply, so this call comes first when neighbouring premises are dark too.

How quickly can an electrician get to a commercial emergency in Nottingham?

That depends on where you are, the time of day and what is already booked, so no honest electrician will commit to a figure before knowing those. Ask for a realistic attendance window and the out-of-hours charging terms when you ring, and get both confirmed in writing. A firm promising a time without asking your address is guessing.

Will the whole premises have to be switched off for the repair?

Usually not. Most faults are confined to one or two circuits and can be isolated at that level, so the rest of the installation keeps running while the work is done. A fault at the incoming supply or the main board is the exception. Your electrician should say what has to come off, and for how long, before starting.

Emergency electrical help for Nottingham business premises

Somo Electrical is a NAPIT-registered electrical contractor, registration number 33320, working with commercial premises across Nottingham including Mapperley. We carry out emergency electrical repairs and ongoing commercial electrical work, and we certify what we put right rather than handing it on.

If something is happening now, call 07733 666004. If it is a fault rather than an emergency, send the details through our online quote form. Either way you get our findings in writing, and we will not price a repair before we have seen it.

Written 16 October 2026. The 105 power cut line and National Grid Electricity Distribution's 24-hour faults number 0800 096 3080 were corroborated through search on 16 October 2026, not retrieved from source. No statutory duty, inspection interval, testing standard or reporting threshold is stated here: those are regulatory claims, no primary source could be opened from the environment this was drafted in, so they are routed to the Health and Safety Executive, to the premises' fire risk assessment and to your own adviser. NAPIT registration 33320 is confirmed by the business. All work described is for a qualified, registered electrician; nothing here is an instruction to carry out electrical work.

commercialelectrical emergencybusiness premisessafetyMapperley

Need Help With This?

Our NAPIT registered electricians are ready to help. Get a free, no-obligation quote today.

Ready to Transform Your Electrical System?

Contact us today for a free, no-obligation quote. Our team of NAPIT registered electricians is ready to provide you with expert service.

  • Free, no-obligation quotes
  • NAPIT registered electricians
  • Full warranty on all work
  • Emergency service available
  • Commercial and residential solutions